stainless steel vents for Hollow wooden boards

[frosties]

Hi, I've got a heap of these stainless steel vents manufactured so get in touch if anyone needs one.

ventricles by frostie's, on Flickr

I wasnt happy with other vent systems available so this is my solution

Theres a little lip around the female part so the male part sits flush on the board. Just 2 turns of an allan key and the the board is vented by the cross hole in the hollow male part

They come with female knurled part, male hollow bolt with 3mm allan head, nitrile rubber washer and an allan key along with fitting instructions
£10 each plus postage, Bulk discounts available too
swing me an E mail @ driftwoodsurfboards@gmail.com

[frosties]

All uk manufacture

[peteuk]

hi frosties, that looks the biz ,a simple mechanical vent is just the best solution for hollow boards or compsand type construction , goretex type although thought of as fit and forget if they do fail its too late ,
i am sure some of the firewire delams are due to vent failure ,good stuff, pete