stainless steel vents for Hollow wooden boards

Any discussion on shaping, designing, repairing and riding surfcraft of any type or shape. Also a good place to ask the 'what board should I buy?' question.

stainless steel vents for Hollow wooden boards

Postby frosties » Sun Dec 30, 2012 12:28 pm

Hi, I've got a heap of these stainless steel vents manufactured so get in touch if anyone needs one.
Image
ventricles by frostie's, on Flickr

I wasnt happy with other vent systems available so this is my solution

Theres a little lip around the female part so the male part sits flush on the board. Just 2 turns of an allan key and the the board is vented by the cross hole in the hollow male part

They come with female knurled part, male hollow bolt with 3mm allan head, nitrile rubber washer and an allan key along with fitting instructions
£10 each plus postage, Bulk discounts available too
swing me an E mail @ driftwoodsurfboards@gmail.com
http://www.driftwoodsurfboards.co.uk/#
User avatar
frosties
 
Posts: 54
Joined: Sat Aug 20, 2011 9:39 pm
Location: cornwall

Re: stainless steel vents for Hollow wooden boards

Postby frosties » Sun Dec 30, 2012 12:29 pm

All uk manufacture
http://www.driftwoodsurfboards.co.uk/#
User avatar
frosties
 
Posts: 54
Joined: Sat Aug 20, 2011 9:39 pm
Location: cornwall

Re: stainless steel vents for Hollow wooden boards

Postby peteuk » Mon Dec 31, 2012 12:49 pm

hi frosties, that looks the biz ,a simple mechanical vent is just the best solution for hollow boards or compsand type construction , goretex type although thought of as fit and forget if they do fail its too late ,
i am sure some of the firewire delams are due to vent failure ,good stuff, pete
peteuk
 
Posts: 330
Joined: Mon Mar 31, 2008 9:55 am


Return to Surfboards - Shaping and Board Design

Who is online

Users browsing this forum: No registered users and 6 guests